주요특징
| MD9289 (MODBUS RS485 NETWORK ADAPTER) | |
Adapter Type |
Slave node (MODBUS/TCP,MODBUS/UDP Server), Dual |
| Protocol | MODBUS/TCP,MODBUS/UDP,HTTP,DHCP,10 TCP Connections |
| Max. Expansion Module | 63 slots |
| Max. Redundancy Data Size (Input + Output + Parameter) |
Max 400 byte |
| Max. Data Size(Input + Output) | Max 128 bytes each slot |
| Max Length Bus Line | Up to 100m from Ethernet Hub/Switch with twisted CAT5 UTP/STP |
| Max. Nodes | Limited by Ethernet Specification. |
| Baud Rate | 10/100Mbps, Auto-negotiation, Full duplex |
| Interface Connector | RJ-45 socket * 2pcs |
| IP-Address Setup | Via DHCP/BOOTP or IOGuide(Crevis Software) |
| IP-Address Range | xxx.xxx.xxx.1 ~ 253 (User area) |
| Serial Port | RS232 for MODBUS/RTU, Touch Pannel or IOGuidePro |
| Serial Configuration (RS232) | Node : 1 (Fixed) Baud Rate : 115200 (Fixed) Data bit : 8 (Fixed) Parity bit : No parity (Fixed) Stop bit : 1 (Fixed) |
| Indicators | 5 LEDs 1 Green/Red, Main module Status (PRI) 1 Green/Red, Module Status (MOD) 1 Green, Physical Connection (LINK) 1 Green, Exchange Data/Traffic Present (ACT) 1 Green/Red, Expansion I/O Module Status (IOS) 2 LEDs (each RJ45 Connector) 1 Yellow, Link/Active 1 Green, Not used |
| Module Location | Starter module left side of M-Series system |
| General specification (Supplied by M7001) | |
| UL System Power | Supply voltage : 24Vdc nominal, Class 2 |
| System Power | Supply voltage : 24Vdc nominal Supply voltage range : 15~28.8Vdc Protection : Output current limit, Reverse polarity protection |
| Power Dissipation | 150mA typical @ 24Vdc |
| Current for I/O Module | 2.0A @ 5Vdc (If except for NA, current for I/O module is about 1.6A) |
| Isolation | System power to internal logic : Non-isolation System power I/O driver : Isolation |
| UL Field Power | Supply voltage : 24Vdc nominal, Class 2 |
| Field Power | Supply voltage : 24Vdc typical (Max. 28.8Vdc) * Field Power Range is different depending on IO Module series. Refer to IO Module`s Specification. |
| Single Wire | 0.205㎟ - 1.3㎟ (24-16 AWG) |
| Torque | 0.8Nm(7 lb-in) |
| Max. Current Field Power Contact | DC 10A Max |
| Weight | 356g |
| Module Size | 25.7mm x 107.5mm x 56.5mm |
| Redundancy | Possible |